- 您现在的位置：买卖IC网 > Sheet目录450 > ISL5216EVAL1 (Intersil)EVALUATION BOARD FOR ISL5216KI
ISL5216
TABLE 7. CIC DECIMATION FACTOR REGISTER (IWA = *002h)
P(15:0)
15:0
P(15:0)
15:6
5:1
0
P(31:0)
31:20
19:14
FUNCTION
Load with the desired CIC decimation factor minus 1.
TABLE 8. CIC DESTINATION FIR AND OUTPUT ENABLE/DISABLE REGISTER (IWA = *003h)
FUNCTION
Set to zero.
CIC output destination (FIR # in FIR processor). Usually set to 00001.
CIC output enable. Active high. When low, the data writes from the CIC to the filter compute engine are inhibited.
TABLE 9. CARRIER NCO/CIC CONTROL REGISTER (IWA = *004h)
FUNCTION
Reserved, set to zero.
CIC barrel shift control.
000000 is the minimum shift factor and 101111 (47 decimal) is maximum shift factor. 000000 = Shift Factor of 0; 011111 = Shift Factor
of 31; 100000 = Shift Factor of 32; 101111 = Shift Factor of 47. This compensates for the CIC filter gain of R N , where N is the number
of enabled CIC stages and R is the CIC decimation factor. The equation used to compute the shift factor is:
Shift Factor = 45 - Ceiling(log 2 (R N )). Use a shift of 45 decimal when bypassing the CIC. Note that shifts of 46 and 47 may cause loss
of MSBs.
Examples:
N R
Shift Factor
5
5
512
8
0
30
13:9
8:6
5
4
3
2:1
CIC stage bypasses. The integrator/comb pairs are numbered 1 thru 5, with 1 being the first integrator and first comb. Bit 13 bypasses
the first integrator/comb pair, bit 12 bypasses the second, etc. The first integrator is the largest. Typically, the stages are enabled
starting with stage 1 for maximum decimation range.
Carrier phase shift. Phase shifts of N*( π /4), N = 0 to 7. These bits remain for backward compatibility with the HSP50216. For new
designs, these bits should be set to 0 and the phase offset programmed into IWA *01CH.
Clear feedback (test signal or for mixer bypass).
NCO clear feedback on load.
Update frequency on SYNCI. Redundant. Set to1. See GWA register F802h.
Number of Carrier Offset Frequency (COF) serial input bits. The format is 2’s complement, early SYNC, MSB first:
00
01
10
11
8
16
24
32
0
P(31:0)
31:0
Enable serial carrier offset frequency (zeros the data already loaded via the COF/COFSYNC pins). To disable the COF shifting see
IWA register *000h.
TABLE 10. CARRIER NCO CENTER FREQUENCY REGISTER (IWA = *005h)
FUNCTION
Carrier Center Frequency (CCF):
This is the frequency control for the carrier NCO. The center frequency control is double buffered. The contents of this register are
transferred to the active register on a write to the CCF Strobe location or on a SYNCI (if load on SYNCI is enabled). The carrier center
frequency is: CCF*f CLK /(2 32 ).
CCF is a twos complement number and has a range of -2 31 to (2 31 -1). f CLK is the input sample rate (ENIx assertion rate) for gated
mode and the clock rate for interpolated mode.
The value in the active register can be read at this address (the center frequency control before the serially loaded offset value is
added). To read the value, either write this address to A(1:0) = 11 and then read at A(1:0) = 00 and 01, or read the value at A(1:0) =
00 and 01 after writing to this address and before writing a new address to either A(1:0) = 10 or 11.
36
FN6013.3
July 13, 2007
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
ISL5217EVAL1
EVALUATION BOARD FOR ISL5217KI
ISL5239EVAL1
EVALUATION BOARD FOR ISL5239
ISL5239KIZ
IC LINEARIZER PRE-DISTORT 196BGA
ISL5416EVAL1
EVALUATION PLATFORM FOR ISL5416
ISL55005IEZ-T7
IC AMP MMIC BIPO BROADBND SC70-6
ISL55007IEZ-T7
IC AMP MMIC BIPO BROADBND SC70-6
ISL55008IEZ-T7
IC AMP MMIC BIPO BROADBND SC70-6
ISL55009IEZ-T7
IC AMP MMIC BIPO BROADBND SC70-6
相关代理商/技术参数
ISL5216KI
功能描述:上下转换器 QUAD DIGITAL DOWNCONVERTER,IND TEMP,0.8M RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128
ISL5216KI-1
功能描述:上下转换器 QUAD DIGITAL DOWNCONVERTER,IND TEMP,1.OMM PITCH BGA PACKAG RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128
ISL5216KI-1Z
功能描述:上下转换器 W/ANL QD DIG DWNCNVRTR 1 OM PITCH RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128
ISL5216KIZ
功能描述:上下转换器 W/ANNEAL QD DIGTL DWNCNVRTR IND TEMP RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128
ISL5217
制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Quad Programmable Up Converter
ISL5217_05
制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Quad Programmable Up Converter
ISL5217EVAL1
功能描述:EVALUATION BOARD FOR ISL5217KI RoHS:是 类别:RF/IF 和 RFID >> RF 评估和开发套件，板 系列:- 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796
ISL5217KI
功能描述:上下转换器 196BGA,-40+85C PROGRAMMABLE QUAD UP CONVERTER RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128